Taking Lighting to Extremes

Die-casting plants are hot, dirty environments that require frequent cleaning with high-power water jets to produce quality castings. The combination can take its toll on lighting systems. At the Abeco die-casting plant in Lewisburg, Tenn., low-bay luminaires were not tolerating the harsh and demanding environment and could not withstand the heavy cleaning-water spray without breach or ingress.

01/01/1970


Die-casting plants are hot, dirty environments that require frequent cleaning with high-power water jets to produce quality castings. The combination can take its toll on lighting systems.

At the Abeco die-casting plant in Lewisburg, Tenn., low-bay luminaires were not tolerating the harsh and demanding environment and could not withstand the heavy cleaning-water spray without breach or ingress. In addition, constant dirt, dust and contaminants collecting on the lamps and internal surfaces of the optical assembly began to degrade output.

"Our lighting system was not conducive to our rigorous cleaning processes and we were progressively losing light output," says Wendall Pigg, quality control manager and tooling coordinator. "We were faced with a decision to either add more fixtures or replace the current ones with new more efficient fixtures."

Rather than install more standard low-bay luminaires, Abeco replaced existing low-bays with fixtures that are expected to reduce lumen depreciation. The system's reflector and lens are mechanically sealed to the enclosure to keep dirt, dust, liquid and moisture outside the optical assembly. The system is also said to significantly reduce the rate of air exchanged by respiration, preventing the rapid suction of outside air.

Abeco installed new 400-watt metal-halide pendant-mounted luminaires in the dirtiest section of the plant, and company officials are pleased with the results so far.

For more information about luminaires from Day-Brite Lighting, circle 103 on the Reader Service Card.





No comments
Consulting-Specifying Engineer's Product of the Year (POY) contest is the premier award for new products in the HVAC, fire, electrical, and...
Consulting-Specifying Engineer magazine is dedicated to encouraging and recognizing the most talented young individuals...
The MEP Giants program lists the top mechanical, electrical, plumbing, and fire protection engineering firms in the United States.
Integrating electrical and HVAC for energy efficiency; Mixed-use buildings; ASHRAE 90.4; Wireless fire alarms assessment and challenges
integrated building networks, NFPA 99, recover waste heat, chilled water systems, Internet of Things, BAS controls
40 Under 40; Performance-based design; Clean agent fire suppression; NFPA 92; Future of commissioning; Successful project management principles
Transformers; Electrical system design; Selecting and sizing transformers; Grounded and ungrounded system design, Paralleling generator systems
Commissioning electrical systems; Designing emergency and standby generator systems; VFDs in high-performance buildings
Tying a microgrid to the smart grid; Paralleling generator systems; Previewing NEC 2017 changes
As brand protection manager for Eaton’s Electrical Sector, Tom Grace oversees counterfeit awareness...
Amara Rozgus is chief editor and content manager of Consulting-Specifier Engineer magazine.
IEEE power industry experts bring their combined experience in the electrical power industry...
Michael Heinsdorf, P.E., LEED AP, CDT is an Engineering Specification Writer at ARCOM MasterSpec.
Automation Engineer; Wood Group
System Integrator; Cross Integrated Systems Group
Fire & Life Safety Engineer; Technip USA Inc.
This course focuses on climate analysis, appropriateness of cooling system selection, and combining cooling systems.
This course will help identify and reveal electrical hazards and identify the solutions to implementing and maintaining a safe work environment.
This course explains how maintaining power and communication systems through emergency power-generation systems is critical.
click me