California Approves CPVC for Hot and Cold Potable Water Distribution

02/22/2007


The California Building Standards Commission (BSC) has approved a final environmental impact report (EIR) prepared by the state’s Housing and Community Development (HCD) Dept. and put its stamp of approval on the use of chlorinated polyvinyl chloride (CPVC) pipes for hot and cold potable water distribution in houses, apartments, hotels and motels anywhere in the state of California.

The state’s action comes after nearly 25 years of stops, starts, litigation and environmental review. The EIR anticipates the market for CPVC pipe in California will swell by two and a half times, from the current 13% market share to 32% compared to copper and other alternatives.

CPVC has technically been allowed for use under the state’s plumbing code, but it was restricted to use in areas where soil or water conditions caused premature failure of copper pipe. It was also restricted to use in buildings no taller than two stories. BSC’s action in approving the EIR removes all restriction on the use of CPVC in residential building, hotels and motels.

“We are truly gratified that authorities in California have finally agreed with their colleagues in 49 other states in recognizing the benefits of plastic pipe for hot and cold water plumbing in buildings,” said Dick Church, executive director of the Plastic Pipe and Fittings Assn (PPFA).

“What has always been ironic to us is that CPVC could only be used in areas where copper pipe failed because of aggressive water or soil conditions. Shouldn’t its ability to perform in the toughest conditions allow it be used in normal conditions? Apparently, that will now be the case, a great victory for consumers,” concluded Church.

Work on an environmental impact report began in 1982, shortly after IAPMO added CPVC to the Uniform Plumbing Code. Work stopped in the late ’80s when California authorities decided an EIR was not necessary, but resumed again nearly 10 years later as a result of litigation.

Opponents of CPVC use now have 30 days to challenge the state’s findings.CPVC pipe meets the requirements of building codes throughout the United States and is also widely used in fire sprinkler systems.





Consulting-Specifying Engineer's Product of the Year (POY) contest is the premier award for new products in the HVAC, fire, electrical, and...
Consulting-Specifying Engineer magazine is dedicated to encouraging and recognizing the most talented young individuals...
The MEP Giants program lists the top mechanical, electrical, plumbing, and fire protection engineering firms in the United States.
2017 MEP Giants; Mergers and acquisitions report; ASHRAE 62.1; LEED v4 updates and tips; Understanding overcurrent protection
Integrating electrical and HVAC for energy efficiency; Mixed-use buildings; ASHRAE 90.4; Wireless fire alarms assessment and challenges
Integrated building networks, NFPA 99, recover waste heat, chilled water systems, Internet of Things, BAS controls
Transformers; Electrical system design; Selecting and sizing transformers; Grounded and ungrounded system design, Paralleling generator systems
Commissioning electrical systems; Designing emergency and standby generator systems; VFDs in high-performance buildings
Tying a microgrid to the smart grid; Paralleling generator systems; Previewing NEC 2017 changes
As brand protection manager for Eaton’s Electrical Sector, Tom Grace oversees counterfeit awareness...
Amara Rozgus is chief editor and content manager of Consulting-Specifier Engineer magazine.
IEEE power industry experts bring their combined experience in the electrical power industry...
Michael Heinsdorf, P.E., LEED AP, CDT is an Engineering Specification Writer at ARCOM MasterSpec.
Automation Engineer; Wood Group
System Integrator; Cross Integrated Systems Group
Fire & Life Safety Engineer; Technip USA Inc.
This course focuses on climate analysis, appropriateness of cooling system selection, and combining cooling systems.
This course will help identify and reveal electrical hazards and identify the solutions to implementing and maintaining a safe work environment.
This course explains how maintaining power and communication systems through emergency power-generation systems is critical.
click me