SEARCH Archives
Loading
Sponsored by:

AHRI launches VRF certification program

AHRI's certification program is for variable refrigerant flow (VRF) multi-split air conditioners and heat pumps.

09/26/2011


AHRI has introduced a new certification program. The equipment in the variable refrigerant plow (VRF) program is rated and tested in accordance with AHRI Standard 1230, Performance Rating of Variable Refrigerant Flow Multi-Split Air Conditioning and Heat Pump Equipment. Systems sized under 65 MBH are currently certified to AHRI Standard 210/240.

This certification program:

  • Covers matched variable refrigerant flow multi-split air-conditioner and multi-split heat pump systems that comply with either the National Appliance Energy Conservation Act (NAECA) or the Energy Policy Act (EPACT), and use distributed refrigerant technology with cooling and heating capacities for outdoor units from 12,000 Btu/h [3508 W] to 300,000 Btu/h [87,692 W] and indoor units from 5,000 Btu/h [1,462 W] to 60,000 Btu/h [17,538 W]. Each indoor unit is designed to condition a single zone.
  • Applies to variable refrigerant flow multi-split systems consisting of the following matched components: a) an outdoor unit with single or multiple compressors or variable capacity compressor or with a variable speed drive; b) indoor unit(s) that have a coil, air movement device intended for single zone air distribution, and a temperature sensing control; and c) a zone temperature control device.
  • Covers VRF multi-split systems and heat recovery VRF multi-split systems covered in AHRI Standard 1230. Included are multi-split, matched system air-conditioners and heat pumps irrespective of their type of electric power source, or secondary fluid (e.g. air-to-air or water-to-air).

  

There are currently five participants in the program: Carrier, Daikin, LG Electronics, Mitsubishi, and Sanyo. Testing will be conducted at Intertek’s testing facility in Plano, Texas. Performance data for certified products can be found in the AHRI Directory of Certified Product Performance.

- Edited by Chris Vavra, Consulting-Specifying Engineer, www.csemag.com 



No comments

Poll of the Week

When engineering systems in military buildings, what’s the most difficult issue you face?
Automation and controls
Codes and standards
Electrical and power
Energy efficiency, sustainability
Fire and life safety
HVAC


Click Here for Poll Archives
Sponsored by:

About Us | Contact Us | Advertise | Subscribe to Magazine | Site Map | Privacy Policy
Home | Channels | New Products | Media Library | Connect | Industry News | Events and Awards | Newsletters | Blogs | Magazine
Control Engineering | Plant Engineering | Consulting-Specifying Engineer
All content copyright © 2010-2013 CFE Media. All rights reserved.