Trends in Renewable Energy Consumption and Electricity

Total Energy consumption declined for a second year in a row to its lowest level since 1996, dropping 10.1% in industrial areas.

04/12/2011


Despite an economic recession and a significant fall in overall energy demand/consumption, the use of renewable fuels grew strongly in 2009. This growth has been supported by federal and state programs, including federal tax credits, state renewable portfolio standards, and a federal renewable fuels standard. The U.S. Energy Information Administration details renewable energy consumption in 2009 and explains the decrease in total energy consumption over the past two years.

Total U.S. Energy Consumption

U.S. energy consumption declined for the second year in a row in 2009, falling 4.8% between 2008 and 2009 to 94.6 quadrillion British Thermal Units (Btus). This follows a 2.1% decline between 2007 and 2008. As a result, total energy consumption in 2009 dropped to its lowest level since 1996.

This is just the third time since 1949 that energy consumption has declined for two or more consecutive years. It declined between 1973 and 1974 and again in 1975. However, consumption rebounded in 1976 above the 1973 level. The longest and steepest decline occurred between 1979 and 1983, when total energy consumption dropped 9.7% and it did not reach the 1979 level again until 1988.

In both of these earlier periods, oil prices that rose steeply and remained at high levels were a major factor in slowing down the economy and hence reducing energy consumption. This time, there has been no steep oil price increase that resulted in permanently higher oil prices; the average annual price per barrel of crude oil was $60 in 2006, $67 in 2007, $94 in 2008, and $56 in 2009. Instead, the economy slowed down mainly due to factors outside the energy sector.

Consumption of all major fuels declined between 2008 and 2009, except for renewables. Coal dropped the most, falling 12%, while petroleum consumption fell nearly 5%, and natural gas consumption fell 2%. Even nuclear fuel consumption fell by nearly 1%. The decline in all of these sources of energy masks the switching of coal to natural gas for electricity generation due to low natural gas prices.

By sector, energy consumption dropped most in the industrial area (10.1%), followed by electric power (4.5%) and then transportation (3.5%). The residential and commercial sectors each experienced declines of under 2%.

Read more…

- Edited by Gust Gianos, Consulting-Specifying Engineer, www.csemag.com



Consulting-Specifying Engineer's Product of the Year (POY) contest is the premier award for new products in the HVAC, fire, electrical, and...
Consulting-Specifying Engineer magazine is dedicated to encouraging and recognizing the most talented young individuals...
The MEP Giants program lists the top mechanical, electrical, plumbing, and fire protection engineering firms in the United States.
2017 MEP Giants; Mergers and acquisitions report; ASHRAE 62.1; LEED v4 updates and tips; Understanding overcurrent protection
Integrating electrical and HVAC for energy efficiency; Mixed-use buildings; ASHRAE 90.4; Wireless fire alarms assessment and challenges
Integrated building networks, NFPA 99, recover waste heat, chilled water systems, Internet of Things, BAS controls
Transformers; Electrical system design; Selecting and sizing transformers; Grounded and ungrounded system design, Paralleling generator systems
Commissioning electrical systems; Designing emergency and standby generator systems; VFDs in high-performance buildings
Tying a microgrid to the smart grid; Paralleling generator systems; Previewing NEC 2017 changes
As brand protection manager for Eaton’s Electrical Sector, Tom Grace oversees counterfeit awareness...
Amara Rozgus is chief editor and content manager of Consulting-Specifier Engineer magazine.
IEEE power industry experts bring their combined experience in the electrical power industry...
Michael Heinsdorf, P.E., LEED AP, CDT is an Engineering Specification Writer at ARCOM MasterSpec.
Automation Engineer; Wood Group
System Integrator; Cross Integrated Systems Group
Fire & Life Safety Engineer; Technip USA Inc.
This course focuses on climate analysis, appropriateness of cooling system selection, and combining cooling systems.
This course will help identify and reveal electrical hazards and identify the solutions to implementing and maintaining a safe work environment.
This course explains how maintaining power and communication systems through emergency power-generation systems is critical.
Consulting-Specifying Engineer's Product of the Year (POY) contest is the premier award for new products in the HVAC, fire, electrical, and...
Consulting-Specifying Engineer magazine is dedicated to encouraging and recognizing the most talented young individuals...
The MEP Giants program lists the top mechanical, electrical, plumbing, and fire protection engineering firms in the United States.
2017 MEP Giants; Mergers and acquisitions report; ASHRAE 62.1; LEED v4 updates and tips; Understanding overcurrent protection
Integrating electrical and HVAC for energy efficiency; Mixed-use buildings; ASHRAE 90.4; Wireless fire alarms assessment and challenges
Integrated building networks, NFPA 99, recover waste heat, chilled water systems, Internet of Things, BAS controls
Transformers; Electrical system design; Selecting and sizing transformers; Grounded and ungrounded system design, Paralleling generator systems
Commissioning electrical systems; Designing emergency and standby generator systems; VFDs in high-performance buildings
Tying a microgrid to the smart grid; Paralleling generator systems; Previewing NEC 2017 changes
As brand protection manager for Eaton’s Electrical Sector, Tom Grace oversees counterfeit awareness...
Amara Rozgus is chief editor and content manager of Consulting-Specifier Engineer magazine.
IEEE power industry experts bring their combined experience in the electrical power industry...
Michael Heinsdorf, P.E., LEED AP, CDT is an Engineering Specification Writer at ARCOM MasterSpec.
Automation Engineer; Wood Group
System Integrator; Cross Integrated Systems Group
Fire & Life Safety Engineer; Technip USA Inc.
This course focuses on climate analysis, appropriateness of cooling system selection, and combining cooling systems.
This course will help identify and reveal electrical hazards and identify the solutions to implementing and maintaining a safe work environment.
This course explains how maintaining power and communication systems through emergency power-generation systems is critical.
click me